American Expedition Vehicles JK Hemi Builder Kit - Installation Guide for 07-11 JK Wrangler - Manual (Page 32)

29
c. AEV AC Lines (body side)
1. Install the liquid line (Condenser to Firewall.) Use the stock hardware to connect the lines.
2. Fasten the line to the ground stud located on the left fender structure immediately behind the ABS
module using the supplied clip.
3. Be sure to lubricate all O-rings prior to assembly.
d. aev ac lines (powertrain side)
1. Reuse the 3.8L AC Compressor: Modification is required (see instructions in Overview Guide.)
2. Install the suction line (Compressor to Firewall) onto the compressor using stock hardware. The
firewall side will be installed when the body is mated to the chassis.
3. Install the AC Discharge line (Compressor to Condenser) to the compressor using the stock hard-
ware. Install the stock pressure transducer. The condenser side will be installed when the body is
mated to the chassis.
4. Be sure to lubricate all O-rings prior to assembly.
e. AEV transmission cooler
1. Install the transmission cooler to the AC condenser. Locate the cooler 3.5” from the top of the con-
denser and 3.5” from the right side of the condenser. Pre-install transmission cooler hose on each
barb of the transmission cooler.
2. Using the Mopar 55038175AA Transmission Cooler lines, remove the OE hose portion (fig. 6) and
flare the lines as shown (fig. 7)
fig. 6 fig. 7