American Expedition Vehicles JK Hemi Builder Kit - Installation Guide for 07-11 JK Wrangler - Manual (Page 33)

30
f. heater hoses
Cut the stock 3.8L hoses as shown (fig. 8a) keeping the center sections. Fit these sections to the
completed powertrain before mating the body to the chassis (fig. 8b.)
fig. 8a
fig. 8b
g. evaporative purge valve hoses
1. Reuse the stock 3.8L hose from the fuel tank to the purge valve. Attach this line to the fuel line us-
ing the stock bracket and a couple zip ties.
2. Use Mopar part #4578627AA hose to go from the intake, around the engine to the purge valve.
This hose doesn’t quite go all the way to the purge valve; you will need to use a portion of the stock
3.8L purge valve line from the purge valve to the engine.