Atec Agilent-EPM Series - Manual (Page 9)

9
N1913A/14A EPM Series Power Meters Performance Characteristics (continued)
Line power
Input voltage range 90 to 264 VAC, automatic selection
Input frequency range 47 to 63 Hz and 400 Hz @ 110 Vac
Power requirement 75 VA (50 Watts)
Battery option operational characteristics 1
The following information describes characteristic performance based at a temperature of 25 °C unless otherwise noted.
Typical operating time Up to 6 hours with LCD backlight on; up to 7.5 hours with LCD backlight off (N1913A power meter).
Charge time Approximately, 2.5 hours to charge fully from an empty state. Power meter is operational whilst charging.
Battery type Lithium-ion (Li-ion)
Battery storage
temperature –20 °C to 60 °C, ≤80 % RH
Environmental characteristics
Electromagnetic
compatibility Complies with the essential requirements of EMC Directive (2004/108/EC) as follows:
• IEC61326- 1:2005 / EN61326- 1:2006
• CISPR11:2003 / EN55011:2007 (Group 1, Class A)
The product also meets the following EMC standards:
• Canada: ICES/NMB- 001:2004
• Australia/New Zealand: AS/NZS CISPR 11:2004
Product safety This product conforms to the requirements of the following safety standards:
• IEC 61010- 1:2001 / EN 61010- 1:2001
• CAN/CSA- C22.2 No.61010- 1- 04
• ANSI/UL61010-
1:2004
Low Voltage Directive This product conforms to the requirements of European Council Directive “2006/95/EC”
Operating environment
Temperature 0 °C to 55 °C
Maximum Humidity 95% at 40 °C (non-condensing)
Minimum Humidity 15% at 40 °C (non-condensing)
Maximum Altitude 4,600 meters (15,000 feet)
Storage conditions
Non-operating storage
temperature –40 °C to +70 °C
Non-operating maximum
humidity 90% at 65 °C (non-condensing)
Non-operating maximum
altitude 4,600 meters (15,000 feet)
Remote programming
Interface GPIB, USB and LAN interfaces operates to IEEE 488.2 standard
Command language SCPI standard interface commands. Code-compatible with legacy E4418B/9B EPM Series, 436A, 437B
and 438A power meters (43X compatibility only with option N191xA-200).
GPIB compatibility SH1, AH1, T6, TE0, L4, LE0, SR1, RL1, PP1, DC1, DT1, C0
1. Characteristics describe product performance that is useful in the application of the product, but is not covered by the product warranty.