Kaiser S45I84XL - Manual (Page 92)

92
EN
Fault codes
(MODELS S 45I70 XL, S 60I70 XL)
WARNING!
In case of an overflow, cut off the main water
supply before calling the service centre. If there is
some water left in the bottom tub caused by
overfilling or slight leakage, the water should be
removed before restarting the dishwasher.
Fault Cause Remedial action
Traces of
rust on
tableware Tableware
unstable agai
st
rust
Wash only the tableware
intended for a dishwasher
Black or
gray marks
on dishes Aluminium
utensils have
rubbed against
dishes Wash in a dishwasher only
the utensils intended for it
Water
remaining
in the
bottom of
the tub This is normal A small amount of clean
water around the outlet on
the tub bottom at the back of
the tub keeps the water seal
lubricated
Plastic
items got
painted Tomatoes,
carrots ketchup,
etc. contain
natural dyers. It
is the reason of
colouring Quantity of a washing-up
liquid or bleaching effect for
this purpose are too
insignificant
Apply more washing-up
liquids (Section see
„Detergent dispenser”).
The painted details any more
will not get former colour
Codes Meanings Possible Causes
Е 1
Longer inlet time Faucet is not opened
Е 4
Overfilled Too much inlet water
Contact an expert of the
service centre
Е 9
Blocking of the
control panel
sensor buttons Outside items or water on the
sensors. Remove all the
items, wipe the panel.