Kaiser KCT6406 - Manual (Page 18)

EN
18
3
5
2
2
2
4
1
––
— —
—
—
H
—
—
USAGE
COOKING ZONES CONTROL
Switching the Touch Control ON/ OFF
stand-by mode
.
Key lock
ON
0
After mains voltage is applied the control initializes for
approx. 1 second before it is ready for operation.
After a reset all displays and LEDs glow for approx. 1
second. When this time is over all displays extinguish
and the control is in the
.
Touch the key to turn on the hob’s
control
It comes a sound signal. The displays of the heating
fields and of the timer show the symbols
After switching-ON the electronic control remains
activated for 20 seconds.
If no cooking zone or timer selection follows within this
period of time, the electronic control automatically
switches back into the stand-by-mode.
If a cooking zone has residual heat, the display shows a
symbol
, .
If the child lock feature was active when switching on,
the timer display shows a symbol
, – locked (also
refer to ).
When the Touch Control is ON it can be switched-OFF
at any time by operating the
key . This is
also valid if the control has been locked (activated child
lock feature).
The key has always priority in the switch-
OFF function.
When the control is it automatically switches-OFF
after 1 minute if no cooking zone or select key has been
operated within this period of time.
If a cooking zone has been selected with heating level
, in 10 seconds it will be deactivated.
If the diameter of the utensil’s bottom is less than 12 cm,
or it does not have ferromagnetic properties, i. e. can
not be heated on induction hob, on the display of the
corresponding heating field will blink symbol
•
( ).
, .
ON/ OFF 1
2
H 3
Lo 4
ON/ OFF 1
ON/ OFF 1
–
5