atwood Air Conditioners (non-ducted AC-1351, AC-1501) - Manual (Page 13)

AC IOM 3/01/2013 rev 1 13
OPERATING INSTRUCTIONS FOR ADJUSTING THE THERMOSTAT
Press to select auto, high,
medium or low fan speed
Fan speed button
Press to activate on/off
timer programming mode
Timer button
Room temperature
setting button
Display timer setting, set or ro om
temperature in C or F
Temperature display
area
Key lock
Sleep button
Press once to select sleep mode
Press again to cancel sleep mode
Press to select cool, dry, heat,
fan
, or auto operation mode
Mode button
Press once to start operation
Press again to stop operation
On/Off button
To receive wireless handset sign al
Infra red reception
SENSOR
ON/OFF
COOL
MODE FAN
FAN
HEAT
DRY
AUTO
TEMP
MED
LOW
HIGH
SLEEP TIMER FURNACE
Furnace
button
This button is valid in heatpump +
furnace model only
Press once to select furnace as
primary heating
Press again to cancel furnace as
primary heating
1. Power On/Off
 Press ON/OFF to start or stop the air conditioner.
2. Temperature setting
 Press or to decrease or increase the set temperature. When any of these buttons is
pressed, temperature display area will flash with the old temperature setting for 4 seconds. Should
there be no further key press it will then return to room temperature display in the range of 0C-50C.
 Press and
FAN
together for 5 seconds will change the temperature setting from C to F. Valid
temperature set range is 16C-30C or 60F-85F.
 Temperature setting is bypassed in Fan mode.
 Temperature display according to set temp. Press
SLEEP
button for 5sec to show room temp until key
is released. In degree F setting, 100 is shown as A0, 110 as B0, 120 as C0, 130 as D0, 140 as E0
and 150 as F0.