B&K Precision 4078 - Manual - Manual (Page 39)

3.14.6 Using Voltage Offset
Through the offset parameter you can add a positive or negative DC level to the output waveform.
To set voltage offset:
1. Press Waveform to display the menu.
2. Press F3 :OFST to display the offset setting.
3. Use the rotary input knob or the numerical keys to set the voltage offset.
To turn the voltage offset OFF, repeat the steps above, but set the offset voltage level to 0.
3.14.7 Storing and Recalling a Waveform Generator Setup
You can store up to 49 front-panel setups in a part of non-volatile Flash known as the settings storage memory. When
you recall a stored setup, the front-panel settings change to match the settings in the stored setup. These stored and
recalled settings include the starting address and length of the arbitrary memory that is loaded in the execution
memory.
Storing Setups
To store the front-panel setup:
1. Press UTILITY to display the menu.
2. Press F2:STORE to select the Store mode.
3. Use the rotary input knob to select a buffer number. Valid buffer numbers range from 1 to 49. Buffer 0 is a read-
only buffer that contains the power-on settings listed in Table 3-2.
Note: The waveform generator does not warn you when you store a setup into a settings buffer that is already
occupied.
Recalling Setups. To recall stored front-panel setup:
1. Press UTILITY to display the menu.
2. Press F2:RECALL to select the Recall mode.
3. Use the rotary input knob to select a buffer number. Valid buffers numbers range from 0 to 49.
Buffer 0 is a read-only buffer that contains the power-on settings listed in Table 3-2.