Bray 98 Series - Manual (Page 13)

All information herein is proprietary and confidential and may not be copied or reproduced without the expressed written consent of
BRAY INTERNATIONAL, Inc. The technical data herein is for general information only. Product suitability should be based solely upon customer’s
detailed knowledge and experience with their application.
S98 O & M : 13
Series 98 Operation & Maintenance
6.5 Torque Module
6.5.1 Disassembling the Torque Module
NOTICE
Either the Spring Module or the Pressure Module must be
removed from the Torque Module to allow for removal of the
Guide Bar and Yoke Assembly from the Torque Module.

from the Guide Block prior to disassembly.



of the Yoke.


(3), half turn at a time alternately till the Housing Cover is
separated enough to pry off the Housing with a blunt tool.

from the Guide Block (25) and the Housing (1).

Block towards the Yoke center and lift the Yoke Assembly
out of Housing.
NOTICE
For smaller models (up to 14E3) this can be done by hand.
Larger models may require use of a hoist to support the weight
of the Yoke Sub assembly. For this, remove the Screw (17) off
the Yoke and fit an eye bolt in place.

Screws (28) and the Retainer Plate (24).


bottom Slider Block.

Housing Cover, if replacement is required.

only be removed for replacement with suitable tools.
6.5.2 Service & Reassembly of the Torque Module

and the Guide Block.

Screws (28), applying a drop of thread lock compound on
the screw threads.

Block (22) generously and slide the Slider Block into the
slot.

between the arms of the Yoke aligning the Yoke Pin bushings
with the lower Slider Block pin hole.

in the Yoke and the Guide Block pin bearings, locating it
in the lower Slider Block hole. Push the Yoke Pin down to
touch the bottom Retainer Plate.

on the Yoke Pin through the upper slot till it rests on the
Guide Block.


and grease the bearing in the Housing and the Yoke seating
raised face.

bearing and push it down to seat it on the raised seating face
in the Housing.

and Guide Block.

top of the Yoke, applying a drop of thread lock compound.
Grease the upper journal of the Yoke.

in the Housing Cover and locate it on the Yoke upper journal
Bolts (12). Ensure the set screws on the Housing Cover are
backed off fully.

the Yoke, and set the screw on Yoke into the slot in the plate.

Plate Bolts. Fit the indicator on the drive shaft.

Torque Module Housing