Bray 98 Series - Manual (Page 35)

All information herein is proprietary and confidential and may not be copied or reproduced without the expressed written consent of
BRAY INTERNATIONAL, Inc. The technical data herein is for general information only. Product suitability should be based solely upon customer’s
detailed knowledge and experience with their application.
S98 O & M : 35
Series 98 Operation & Maintenance
17.1.2 Adjusting Extended Stopper
Connect air supply to the rod end side port of the pneumatic cyl-
inder, adjust the extended stopper screw to required position, and
reverse the actuator direction to stop movement by the extended
position.
NOTICE
The Extended Stopper is not designed as a jackscrew. Do not
use this to manually override the actuator. Always adjust the
stopper with no load on it.
WARNING
Never remove the assembly fasteners without first backing off the
Extended Stopper fully to release any load on it.
17.2 Installing Extended Stopper for Spring
Module
4HIS

ACTUATOR


THE

ASSEMBLY

TABLE
17.2.1 Adjusting Extended Stopper

THE

NOTICE
The Extended Stopper is not designed as a jackscrew. Do not
use this to manually override the actuator. Always adjust the
stopper with no load on it.
WARNING
Never remove the assembly fasteners without first backing off the
Extended Stopper fully to release any load on it.