Bray 70 Series SERVO PRO DeviceNET - Manual (Page 6)

S70 DeviceNet Servo Installation & Maintenance Manual
2000 BRAY CONTROLS Page 5 of 24
2.2.3 DeviceNet Connector J7
The Series 70 Actuator is shipped with a DeviceNet Open Style connector as shown below:
This connector has the following pin-out:
Figure 2: DeviceNet Open Style Connector
Description Wire Color
V-, CAN power supply return Black
CAN Low Blue
Shield Bare/Gray
CAN High White
V+, CAN power supply source Red
Table 2: DeviceNet Wire Colors
2.2.4 Feedback Pot J4
The Feedback Potentiometer on the Series 70 Actuator reports to the S70 the actual position of
the valve. The S70 will not operate without this connection in-place.
Figure 3: Feedback Pot Connector J4
Description Requirements
Reference voltage (Gray) Potentiometer full open end point
Voltage relative to valve position (Orange) Potentiometer wiper
Ground (White) Potentiometer full close end
point
V+ CANH SHIELD CANL V-