MoTeC CDL3 - Manual (Page 10)

10 Introduction
Video
MoTeC’s Video Capture System (VCS) is an integrated in-car camera
system, recording video and audio using the MPEG-2 video compression
format at broadcast quality. It includes a built in real-time graphics
processor that allows sensor data to be overlaid onto the video in real-time
without the need for additional hardware. The CAN interface enables
communication with other devices, for example to set Auto Start/Stop
Recording conditions and synchronisation.
Multiple video streams, from in-car cameras for example, can be linked
with logged data for synchronised playback of footage alongside other
analysis components.
Note: Synchronisation can be completed manually or automated by using
the CAN Video Sync feature.
Lambda Measurement
PLM
The PLM Professional Lambda Meter measures the air fuel ratio over a
wide range of mixtures with fast response time. It is compatible with Bosch
LSU and NTK UEGO Lambda sensors and displays the Lambda readings
via the integrated display.
LTC/LTCD/LTC NTK
LTC Lambda to CAN modules provide accurate Lambda measurements
even when the exhaust gas temperature changes rapidly. They are
compatible with the Bosch LSU 4.9 / NTK Lambda sensors and transmit
Lambda readings via the CAN bus.
Remote Displays
A remote display device may be connected to the CDL3 to allow display of
any value that the Dash Logger calculates, such as lap times and warning
alarm messages.
The Club Dash Logger supports MDD displays which are connected via CAN.
PDMs
Power Distribution Modules are designed to replace conventional relays,
fuses and circuit breakers by providing electronically switched power to the
various electrical systems in the vehicle. This simplifies wiring and switch
requirements, while increasing reliability.
Full diagnostic information, including output currents and error status, can be
transmitted via CAN to the Dash Logger.