MoTeC CDL3 - Manual (Page 46)

46 Configuration
The alarms remain active until they are acknowledged, either by a driver
activated switch or automatically after a defined period of time.
The warning alarm limits are fully programmable and may include up to 6
comparisons to ensure that the alarms are only activated at the correct time.
For example, an engine temperature alarm may activate at 95
°C if the ground
speed has been above 50 km/h for 30 seconds. The speed comparison
avoids the alarm showing during a pit stop due to heat soak. Additionally
another comparison could be set at a higher temperature to cover all other
situations.
The comparison values can be automatically incremented or (decremented)
when an alarm occurs. For example the engine temperature alarm may be set
at 95
°C with and increment of 5 °C, so the second time the alarm activates at
100 °C. A limit may be set on the number of times the comparison value is
allowed to increment. An alarm may return to its original value after a period
of time, in case the alarm condition was temporary.
The alarms can be dependent on the current display mode (Warm-up,
Practice or Race).
Other Functions
The Dash logger can perform many other functions accessible from the
Functions
menu including the following:
Shift Lights – to control up to four staged shift lights
Shift Light Module – to configure MoTeC's SLM-C or SLM