MoTeC PDM30 - Manual (Page 16)

MoTeC Installation 13

To start the program after installation, click
Start > All Programs > MoTeC > PDM Manager
Updating PDM Manager Software
Software updates are available to give access to the latest features.
Download the latest software version from the website and follow the software
installation instructions to update to the new version.
To update the associated firmware in the device select Update Firmware from
the Online menu. For more information refer to Operation.
Connecting the PDM to a PC
The PC communicates with the PDM via the CAN bus.
The connection to the CAN bus is via USB through a MoTeC UTC.
To connect through a UTC, a mating connector for the UTC must be wired to
the PDM's CAN bus.
Refer to UTC Wiring for PC Connection and CAN Bus Wiring Requirements
for more information.
The PC must connect to the PDM at the configured PDM CAN bitrate. Refer
to the Operation section for details about CAN bitrate configuration.
Note: The MoTeC CAN cable (#61021) cannot be used with the PDM.