Kaiser С фронтальной загрузкой - Manual (Page 38)

Display and duration of the washing cycle
With each program selected with the rotary handle 1,
the corresponding spin speed and the duration of the
cycle will appear on the display 2; this time will
decrease until it arrives at zero when the program is
finished and symbol 3, END appears on the display. At
this point it will be possible to take out the laundry.
Light indication of the washing cycle
During the washing cycle you can observe which
operation is running at that moment. Four main
functions PREWASH/ MAIN WASH, RINSE,
SPIN, END are highlighted by the corresponding
LEDs 4, 5, 6, 7. After the spin phase, the
corresponding LED will stay lit for approximately 2
minutes this is the time lapse necessary before the door
can be opened. At this point, the END LED 7 will light-
up.
Bio-Ferment-Wash
The programs of this washing machine are made to
promote the special functions, the resolving of the
bioferments which are included in the detergents. The
bioferments remove in the best way hard to remove
albuminous stains (e.g., milk, blood, chocolate).
Electronic unbalance detection devicel
This washing machine is equipped with a special
electronic control system for correctly balancing the
wash load. Prior to each spin, the system ensures that
the washing is evenly distributed in the drum.
1
Caution! In the Cotton programs, the duration of
the washing cycle initially shown by the display
can vary, since it can be affected by various
factors such as temperature, water inlet pressure
and quantity of laundry loaded in the drum. During
the wash, the machine's electronics will
automatically alter the time required for the cycle
set according to these factors, thus achieving the
best Performance in the best time.
2
3
4 5 6 7
38
EN