CEMB USA K22 (C) - Manual (Page 10)

I 0685 - 10
5
GB
5.3.2 - Correcting the unbalance
STATIC: Apply two identical correction weights at the highest point of the wheel, one on the inside shoulder and
the other on the outside shoulder of the rim. Each weight is half the value indicated by the display.
If you make the correction with lead wire, springs or clamps applied to the spokes, divide it onto one, tow
or more spokes, according to the size of the unbalance.
DYNAMIC: Apply the adhesive weights to the shoulders of the wheel rim in the positions indicated by the display for
each of the sides.
Correction of inner side Correction of outer side
Digital readouts with LED ‘s 3 - 4 lit up indicate the correct angular wheel position to mount the counterweights (12
o’clock position).
In the event of unbalance less than the selected threshold value
0
is displayed in place of the unbalance
value , with it is possible to read the values below the selected threshold gr. by gr.
N.B.: In rare cases and in temperature conditions near 0°, the wheel balancer automatically activates a
special measuring cycle involving two successive measurements.
During the unbalance measurement, the word “START” reappears to indicate to the user to bring
the wheel back up to speed. The accuracy of the unbalance values and the reliability of the wheel
balancer remain unchanged.
5.4 - Recalculating unbalance values
▪ Set the new dimensions as described above.
▪ Press , without repeating the spin.
▪ The new recalculated unbalance values will be displayed.