CEMB USA K22 (C) - Manual (Page 8)

I 0685 - 8
3
3a
3b
3c
3d
3e
GB
5 - INSTRUCTIONS FOR USE OF THE WHEEL BALANCER
5.1 - Using the gauge installed on the machine
Use the gauge always in the upper position A
Indication of gauge in movement
5.2 - Automatic dimension setting
Setting valid for the DYNAMIC and STATIC correction modes.
Extract the gauge up to the barycentre of the inside correction
weight.
Hold it in this position until the symbol shown in Fig. 3d is
displayed.
Indication of dimensions acquired
Return the gauge to rest position. The machine has automatically
detected DISTANCE + DIAMETER and goes to MANUAL WIDTH
SETTING.
Set accurately the distance ‘b’ between the barycentres of the
weights where they will be applied (
MANUAL DIMENSION
PRESETTING
)