CHIEF CM2C40 User Manual
Page 10
CM2C40
Installation Instructions
10
Figure 11
7.
Route cables under cable pulley and up over top of cable
pulley. (See figure 10) and (See figure 11)
8.
Route one cable from front (black) cable clamps through the
#2 cable opening and straight down next to the cable pulley
center shaft. (See figure 10) and (See figure 11)
9.
Route one cable from front (black) cable clamps through the #3
cable opening and straight down next to the other side of the
cable pulley center shaft. (See figure 10) and (See figure 11)
10. Route one cable from rear (gray) cable clamps through the
#2 cable opening and straight down next to the cable pulley
center shaft. (See figure 10) and (See figure 11)
11. Route one cable from rear (gray) cable clamps through the #3
cable opening and straight down next to the other side of the
cable pulley center shaft. (See figure 10) and (See figure 11)
IMPORTANT ! :
Ensure that cables are not twisted! Cables
from front (black) of upper cable clamp (See figure 10) must be
on front of cable pulley (See figure 11) and front of lower cable
clamp (See figure 10). Cables from rear (gray) of upper cable
clamp (See figure 10) must be on rear of cable pulley (See
figure 11) and rear of lower cable clamp (See figure 10).
12. Continue routing cable(s) down through lower cable
clamps. (See figure 10)
13. Tighten upper cable clamp making certain cables are
properly seated in clamp and are not pinched.
CAUTION:
OVERTIGHTENING OF CABLE CLAMPS CAN
CRUSH CABLES LEADING TO DAMAGE TO EQUIPMENT!
DO NOT over tighten cable clamps.
14. Starting at upper cable clamp and working downward,
remove slack from all cables and tighten lower cable
clamps. (See figure 10)
15. Slide cable guide side cover over CM2 mount lining up two
holes in cable guide side cover with two holes in CM2
mount. (See figure 12)
Figure 12
16. Secure cable guide side cover to CM2 mount using two
screws (removed in Step 1). (See figure 13)
Figure 13
8
6
9
8
7
9
Cable
pulley
center
shaft
10
11
Cable guide
side cover
15
x 2
16