CHIEF PWR - Manual (Page 10)

PWR Installation Instructions
10
Roll Adjustment
The PWR allows for the horizontal alignment (Roll)of the display
to be adjusted up to 2° right or left to level the display after
installing.
To adjust Roll:
1. Loosen the roll tension adjustment nut located on the back
side of the faceplate assembly. (See Figure 10)
2. Level display.
3. Tighten roll tension adjustment nut. (See Figure 10)
Figure 10
Swing Arm Tension Adjustment
Swing arm tension is pre-set at the factory and is adjusted to
accommodate displays with weights near the top of the mounts
capacity.
If smaller displays are used it may be difficult to reposition the
display after mounting. Swing arm tension can be adjusted to
compensate for smaller display by:
The display must be mounted prior to adjusting swing arm
tension.
1. Locate the adjustment bar (H) and adjustment wrench (J).
2. Place adjustment bar (H) into socket head cap screw
located at swing arm pivot point. (See Figure 11)
NOTE: The display may need to be repositioned in order to
gain access to the tension adjustment screw(s).
3. Check swing arm tension. If desired tension is present,
tension adjustment is complete. If additional tension
adjustment is required, repeat steps 2 thru 4 until desired
tension is achieved.
NOTE: If changing from a smaller display to a larger display
may be necessary to increase swing arm tension.
Figure 11
4. Using the adjustment wrench (D), turn adjustment bar (C)
clockwise to increase swing arm tension or
counterclockwise to reduce swing arm tension. (Small
adjustments of 1/8 turn or less are typically all that is
required to achieve desired tension.) (See Figure 12) and
(See Figure 13)
Figure 12
Figure 13
2
1
3
Socket Head
Capscrew
(C) x 1
(D) x 1
DECREASE
INCREASE