CHIEF PWR User Manual
Page 6
PWR
Installation Instructions
6
Mount Lateral Position Adjustment
The PWR is designed to allow up to 5" of right or left lateral
adjustment after being mounted to the wall. This lateral
adjustment can be used to more precisely position where the
center of the display is located when installation is complete.
To adjust the mounts lateral position:
1.
Remove display if installed.
2.
While holding swing arm, remove two hex head cap screws
and two washers securing swing arm to upper wall channel.
(See Figure 4)
3.
While holding swing arm, remove two hex head cap screws
and two washers securing swing arm to lower wall channel.
4.
Set hardware aside for reuse. (See Figure 4)
5.
Slide swing arm left or right until desired location is reached
making sure mounting holes in swing arm upper and lower
mounting plates align with mounting slots in upper and
lower wall plates. (See Figure 4)
6.
Secure swing arm to upper and lower wall channels using
hex head cap screws and washers set aside during steps 1
and 2. (See Figure 4)
Figure 4
Lower Wall Channel
Upper Wall Channel
Lower Swing Arm
Mounting Plate
Upper Swing Arm
Mounting Plate
Hex Head Cap Screw and Washer
Hex Head Cap Screw and Washer
2
4
4
1