CHIEF XVAUB - Manual (Page 6)

XVAU Installation Instructions
6
Assembly and Installation
Packaging Removal
NOTE: The XVAU cart needs to be removed from the
packaging pallet prior to camera shelf or display
installation.
1. Use 1/2” socket head wrench to remove four bolts and
washers holding XVAU cart (A) to packaging pallet. (See
Figure 1)
2. Remove two packaging boards from top of pallet. (See
Figure 1)
WARNING: XVAU cart weighs approximately 65 lbs (29.5
kg)! Always use proper lifting techniques and at least two
people to lift cart from packaging pallet! Failure to take
adequate precautions can result in serious personal injury or
damage to equipment!
3. Using two people, carefully lift XVAU cart from packaging
pallet. (See Figure 1)
Figure 1
Camera Shelf Installation
Assembling Shelf to Upright
1. Attach shelf (H) to upright (N) using three 1/4-20 x 1/2”
Phillips pan head machine screws (M). (See Figure 2)
Figure 2
Attaching Shelf Assembly to Mount
1. Lower shelf assembly onto head assembly, placing shelf
assembly hooks over extrusion. (See Figure 3)
Figure 3
2. Attach retaining bracket (J) to upright, pressing retaining
bracket against head assembly and tightening, using four
10-24 lock nuts (K). (See Figure 4)
Figure 4
Installing Camera Shelf Components
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located on the camera mount does not
exceed 10 lbs (4.5 kg).
NOTE: OPTIONAL: Slots are provided in shelf for strap (not
included) to hold component in place. (See Figure 5)
x 4
1
3
3
2
boards
1 (M) x 3
(H)
(N)
1
head assembly
shelf assembly
(column not shown
for clarity)
(J)
2 (K) x 4
head
assembly
(column not shown
for clarity)