CHIEF XVAUB - Manual (Page 9)

Installation Instructions XVAU
9
Cable Management
NOTE: The following cable management options may vary
based on type of display being mounted and user
preference.
FCA Clips
1. Place FCA clip (F) into groove on back of Fusion mount with
clip handle in a vertical position. (See Figure 11)
2. Rotate FCA clip (F) 90° in either direction until clip handle is
in a horizontal position. (See Figure 11)
3. Repeat Steps 2-3 for all clips to be installed.
Figure 11
4. Route cables along FCA clips to be used for cable
management. (See Figure 12)
5. Use cable ties (G) to secure cables to FCA clips. (See
Figure 12)
Figure 12
6. Route cables from display through inside of cart assembly
attaching at cable management attachment points and/or
accessory bracket as desired. (See Figure 13)
IMPORTANT ! : Route cables when display is at its
highest point and make sure enough slack exists so that
height may be adjusted without straining the cables!
NOTE: Rear covers may need to be removed to route cables
properly. See Rear Cover Removal Section for details.
Figure 13
Cable Hooks
1. Use four 1/4-20 x 1/2” Phillips pan machine screws (D) to
attach four cable hooks (C) to bottom of cart assembly (E).
(See Figure 14)
Figure 14
1
2
2
clip handle
(F)
4
5 (G)
6
6
6
clips
underneath
(back cover hidden
for clarity)
(C) x 4
(D) x 4 1
(E)