ClimaCool SHC onDEMAND 30, 50, 70, 85 Manual - Manual (Page 4)

www.climacoolcorp.com
2
Pre-Installation
Inspection
Upon receipt of equipment, carefully check the shipment
against the bill of lading and inspect each chiller for any
damage incurred during shipment. Thoroughly check for
any visible damage of control panels and electrical
and/or refrigeration components or broken copper lines.
The carrier must make proper notation of any damages or
shortages on all copies of the bill of lading and complete
ƒ ‘‘ ƒ””‹‡”‹•’‡ –‹‘”‡’‘”–’”‹‘”–‘›‘—”ƤƒŽ
acceptance of the shipment. Note: It is the responsibility
‘ˆ–Š‡’—” Šƒ•‡”–‘ƤŽ‡ƒŽŽ‡ ‡••ƒ”› Žƒ‹•™‹–Š–Š‡
carrier. In addition, please notify the ClimaCool Customer
Service Department at 405-815-3000
or customerservice@
climacoolcorp.com of all damage immediately.
Storage
Chillers should be stored in an upright position and kept in
a clean, dry area.
Handling of Modules
Carefully remove the module’s packaging. The chiller’s
steel base cutouts provide maneuverability by forklift or
’ƒŽŽ‡–Œƒ ‹–‘‹–•ƤƒŽ’‘•‹–‹‘ȋ‡‡‹‰‰‹‰ƒ†‹ˆ–‹‰
Procedures Figures 1, 2, and 3 on page
7). Verify that all
header grooved couplings and mounting hardware kits are
on site prior to connecting the modules.
Rigging and Lifting
Each module should be lifted by using a pallet jack or fork
lift. If it is necessary to utilize a crane for rigging or lifting,
each module shall be lifted by using lifting straps and
•’”‡ƒ†‡”„ƒ”•—•‹‰”‹‰‰‹‰’‘‹–•‹†‡–‹Ƥ‡†‘’ƒ‰‡͛Ǧ
Rigging and Lifting Procedures.
Warranty
To ensure proper equipment longevity, design performance
and reliability, all ClimaCool chillers must be installed,
operated and maintained in accordance with the
appropriate ClimaCool IO&M manuals. Water quality is of
the utmost importance for the proper care and maintenance
of your modular chiller system and regular treatment of
the water will increase longevity of your system. Failure
–‘’”‘˜‹†‡ƒ†‡“—ƒ–‡ƤŽ–”ƒ–‹‘‘”–”‡ƒ–‡–‘ˆ‡˜ƒ’‘”ƒ–‘”
ƒ† ‘†‡•‡”™ƒ–‡”™‹ŽŽ˜‘‹†–Š‡Ž‹ƒ‘‘Ž‘†—Ž‡ǯ•
warranty. A factory authorized technician is required to
perform the startup of your ClimaCool chiller. Please contact
the ClimaCool Customer Service Department at 405-815-
3000 or [email protected] to schedule
a date for your startup. There is a ‹‹—‘ˆ͗™‡‡•ǯ
notice required to schedule your factory startup.