Contemporary Research ICC2-ATSC+ Manual - Manual (Page 10)

Contemporary Research 10 ICC2-ATSC
Front Panel Setup
To Enter a Front Panel Programming Mode:
1. Press and hold the Power button, then press the Volume Up button
2. Release all buttons, the ICC2-ATSC+ will now be in the front-panel programming mode. The Air LED
will flash, indicating programming mode.
3. The first two digits show the mode, the second show the option.
4. Changes are saved in non-volatile memory as they are entered.
5. The Volume up/down buttons scroll through programming modes, forward and reverse.
6. The Channel up/down buttons scroll through possible options for each mode.
To Exit the Front Panel Mode
Push and release the Power button.
Mode 0-9 Parameters
RF Tune 0.0 0=CATV (Default)
1=Off-Air
2=IRC
3=HRC
4=Cable Auto
Baud Rate 1.1
1.2
1.3
1.4
1.5
1.6
1.7
300
600
1200
2400
4800
9600
19200
Unit Number 2.1 1-99 (The LCD can’t show a higher number. It's easier to use the Menu 999
function on the next page. Set IR Mode 18.1 to 18.0 to see the onscreen
character generator. Once you’re at the device # menu, you can enter the unit’s
address using the number keys on the IR remote.)
Zone Number 3.0 1-15 System device number is (Unit + (Zone * 256))
Panel Lockout 4.0 Reserved (performed by LM command)
Power-up Volume 5.0
5.X
Restore previous level (default)
1 – 63 sets volume level
Firmware Version 6.20 Ex: Version 2.0 -
Press and hold Channel Up, then Power to restore tuner to default settings
Press and hold Channel Up and Down, then Power to scan channels
Captions 10.0
10.1
Captioning off (default)
Captioning on
Caption Mode 11.1
11.2
11.3
11.4
11.X
1=Caption 1 (default)
2=Caption 2
3=Caption 3
4=Caption 4
5-8= Text 1-4 (rarely used)
Video Detect 12.3 No AV mute (fixed)
AV Status 13.0 No AV status (default)
Label Mode 14.2 Numeric (fixed)
IR Receive 15.9 0= Off, 9=Receive IR
Digital Captions 17.1 1-6, Default is 1
IR Remote 18.1 0=IC-RC
1=HD2-RC
Tune Control 19.0 0=Tune all channels
1= Only tune channels in List
Digital Audio 47.0
47.1
47.2
0=AC-3– Dolby 5.1
1=PCM (set to this for audio through HDMI)
2=PCM Variable (default)
HD Output 48.0
48.2
RGB (Default)
Component
HD Format 49.0
49.1
49.2
49.3
0=1080i (Default)
1=720p
2=480p
3=480i