Contemporary Research ICC2-ATSC+ Manual - Manual (Page 4)

Contemporary Research 4 ICC2-ATSC
Specifications
Physical
Size (HWD): 8.5” [216mm] wide x 2.0” [51mm] height (1.5 RU) x 8.0” [203mm] deep
Weight: 1.94 lbs [890 g]
Enclosure: Steel with black powder coat paint
Mounting: 2/1.5RU Rack mounting for one or two units side-by-side optional (RK1/2-HD+,
RK1S/RK2S-HD+)
Front Panel
Display: Red LED Channel Display, dot separated major and minor channel numbers, dot at end indicates
Off-Air tuning
IR: IR sensor
Control: Power, Menu, and Select buttons, navigation using Up and Down (Channel Up and Down) buttons
Left and Right (Volume Down and Up) buttons
LEDs: RS-232 RX (Yellow), RS-232 TX (Red), Net (Green – flashes every second to confirm iC-Net
control signal)
Rear Panel
RF In: Air/Cable, ‘F’, female, 75 ohm impedance, -10 to 15 dBmV typical, receives RF control channel
RF Out: ‘F’, female, Passes RF channels to Air/Cable input, cable included
Air/Cable: ‘F’, female, 75 ohm impedance, -10 to 15 dBmV typical
A/C Jack: 3.5mm jack for RF-AB Air/Cable Switch
Video Output: Simultaneous HDM and NTSC video, switch between RGB and Component
Video Out: RCA composite video output, 1V p-p at 75 ohm impedance, 480i
Component Out: 3 RCA Y, Pr, Pb outputs (1080i/720p/480p/480i)
RGB Out: RGBHV DB-15 female (1080i/720p/480p, 59.95 Hz)
HDMI: HDMI receptacle, Type A, HD video and digital audio, version 1.3 (1080i/720p/480p), HDCP
Use PCM mode if HDMI audio connection is used to most displays (not all have Dolby)
Audio Output: Simultaneous HDMI, Coax, Optical, and Stereo
Digital Audio SPDIF: Coax and TOSlink optical output, Dolby 5.1 AC3/PCM/Variable PCM
Analog Audio Out: Stereo RCA audio, Mono, Stereo, or SAP, variable level
RS-232 Control: DB-9 male, RS-232 data link to control system or PC, up to 9 tuners, 300-19,200 baud
IR In: 3.5mm stereo jack for optional IR-RXC IR Receiver
Sleeve= DC power+ from power jack input, limited to less than 100mA
Ring=DC power– (GND)
Tip= IR data signal
Power In: 2.1mm coaxial jack (inside center conductor positive)
1.1 A maximum, 11.5 to 15 VDC, 12 VDC typical