Contemporary Research ICC2-ATSC+ Manual - Manual (Page 11)

Contemporary Research 11 ICC2-ATSC
On-Screen Menus (IC Mode)
The remaining installation steps use the IR remote and the built-in character generator of the
ICC2-ATSC+.
1. Change the IR Remote mode in front-panel menu 18 to IC-RC (18.0). This will enable the
character generator to display the menus below.
2. Touch Menu, then 999, then Enter.
3. The text CR MENU> should appear on the screen.
4. Key in one of the commands shown below, then press Enter to activate.
5. Note that, in Menu mode, the Channel Down key acts as a backspace/delete key.
Command Function
45678 Display firmware version
45679 Display the unit’s device #. At this point, you can use the Channel Down key as a
Delete key, enter a new device # with the remote’s numeric keypad, then hit Enter to
save the new number.
45700 Display current projector/monitor control commands. The code is installed by CR
when the unit ships, codes can be changed over the RF.
See RS-232 Control Codes on the next page.
45718 IR Remote Type
0=IC-RC
1=HD2-RC
45719 Tuning Control
0=Tune all channels
1= Only tune channels in List
45720 Set Display/Projector Input
Enter code 1-19. See page 23 in the ER section for input codes
65478 Reset controller, similar to disconnecting power then restarting.
65487 Initialize to factory default settings: Power on, unlocked, display channel 11, channel
ring set to 4, 5, and 11, Group 0. Note that this command works even if TV power is
off or control is locked out.
65480 Enable constant Net transmit to the Head-End. This is used for measuring the signal
strength of the unit’s RF output. Press Enter to stop transmit or the unit will
automatically stop after 50 seconds.
65481 Display DA transmitter frequency control voltage – should be 2000 - 3150.
65482 Display iCC-Net RF receive signal strength. Shows Net RX if receiving the
iC-
HE’s “heartbeat” pulse once per second, !NET RX if not.
65483 Display DF transmitter frequency deviation – should be 245 - 300