ALLIED Vision Technologies Bigeye G-1100 Cool - Manual (Page 21)

Specifications
Bigeye G Technical Manual V2.1.0
21
Featur
es
Exposure time 9083 μs … 4294.97 s in 1 μs increments
Binning 2x1, 2x2
Gain 0, +6 dB
Gamma 0.45, 0.5, 0.7
ROI available (Note: decreasing ROI does not increase frame rate)
Video-type auto iris available
Trigger modes Continuous mode (image acquisition with maximum frame rate)
IOD mode (Image on Demand: triggered image acquisition)
External trigger event Rising edge, falling edge, any edge, level high, level low
External trigger delay 0 to 51.13 seconds in 1 μs increments
2x2 binning mode: 0 to 102.26 seconds in 1 μs increments
Fixed rate control 0.000233 fps to max. frame rate
Imaging modes Free-running, external trigger, fixed rate, software trigger
Sync Out modes Trigger ready, trigger input, exposing, readout, imaging, strobe,
GPO, CCDTemperatureOK
Internal image memory 32 MByte, up to 11 frames
Inter
faces
Digital interface IEEE 802.3 1000BASE-T (GigE Vision V1.2 compliant)
GigE connector RJ45 (8P8C) with horizontal screw-locks
I/O port connector 20-pin Mini D Ribbon (MDR) shielded I/O connector with screw-locks
Camera control interface GenICam V1.0 compliant
I/O 4 inputs (3 optocoupled)
4 outputs (3 optocoupled)
Oper
ating conditions
Operating temperature 0 °C to +35 °C ambient temperature (without condensation)
Stabilized cooling
temperature -10 °C (Peltier cooling)
(up to +25 °C ambient temperature)
Power requirements +12 V (+5 %), max. 3 A (during camera start-up: inrush current >= 4
A for 20 ms, capacitive load < 2000 μF)
Power consumption Max.
36 watts
Typical
18 watts (@ 12 V DC)
(maximal frame rates at full resolution)
Feature Specification
Table 4: Specification Bigeye G-283B Cool
Note

The number of frames (StreamHoldCapacity) depends on
resolution and pixel format. Listed number of frames is
typical for full resolution and Mono8.