Analog Way Broad Scan HD - Manual (Page 25)

BROAD SCAN (HD/SDI) Chapter 4 : FRONT PANEL DISPLAY MENU DESCRIPTION (continued)
4-5. FUNCTIONS DESCRIPTION (continued)
[LOGOS/FRAME] Available on BHD930 & BSD830 models.
[Frame ON/OFF]. Display ON or OFF the stored frame onto the output.
[Logo]
[Logo OFF]: Display off the logo.
[Logo 1]: Display the logo 1.
[Logo 2]: Display the logo 2.
[Logo 3]: Display the logo 3.
[Logo 4]: Display the logo 4.
[Logo Animated]: Display the animated logo.
[Record frame]
This mode allows storing up a frame in order to display them at any time during the show.
[Size]
Adjust the size of the frame area with  + ENTER.
[Position]
Adjust the position of the frame area with  + ENTER.
[Store]
This function allows storing the displayed image (frame). Presses ENTER to start the memorization of the
frame. The memorization will take about 2 minutes.
[Record logo]
This mode allows storing up to 4 logos in order to incrust them into the displayed image. Select an item with 
+ ENTER.
[Size]
Adjust the size of the logo area with  + ENTER.
[Position]
Adjust the position of the logo area with  + ENTER.
NOTE: The logo area is limited at an eighth (1/8) of the displayed area.
[Luma key level]
This function allows "erasing" the darkest or brightest portions of your logo area in order to make special
logo contour. Select the luma key type (White or Black) and adjust the luma key level with  +
ENTER.
[Cut out color]
This function allows coloring the "erased portions" of the logo area in order to make special logo contour.
[Store]
This function allows storing the logo into one of the 4 memories. Select a logo memory with  +
ENTER. The memorization will take few seconds.
PAGE 25