Analog Way Broad Scan HD - Manual (Page 26)

Chapter 4 : FRONT PANEL DISPLAY MENU DESCRIPTION (continued) BROAD SCAN (HD/SDI)
4-5. FUNCTIONS DESCRIPTION (continued)
[Record anim]
This mode allows storing an animated logo in order to incrust them into the displayed image. Select an item with
 + ENTER.
[Position]
Adjust the position of the logo area with  + ENTER.
[Size]
Adjust the size of the logo area with  + ENTER.
NOTE: The logo area is limited at an eighth (1/8) of the displayed area.
[Luma key level]
This function allows "erasing" the darkest or brightest portions of your logo area in order to make special
logo contour. Select the luma key type (White or Black) and adjust the luma key level with  +
ENTER.
[Cut Out color]
This function allows coloring the "erased portions" of the logo area in order to make special logo contour.
[Recording time]
Adjust the recording time with  + ENTER.
[Store]
This function allows storing the logo into the memory. The memorization will take few seconds.
[Erase frame]
This function allows erasing the memorized frame.
[Erase logo]
This function allows erasing the memorized logos.
[CONTROL]
[Version]
Status of the internal firmware.
[Zoom type]
Status of the internal firmware.
[Direct zoom]: The zoomed area is direct displayed.
[Dynamic zoom]: The zoomed area is progressively displayed.
[Auto frame ON/OFF] Available on BHD930 & BSD830 models.
Display automatically the Frame when the sync. of the selected input is not anymore detected.
[RS232/LAN port]
Select the needed communication port with  + ENTER.
[RS232]: Enables the RS-232 communication port. (Default setting).
[LAN]:
Enables the LAN communication port.
IMPORTANT: To avoid addresses conflict, configure the LAN communication port (with the LAN setup menu)
before activates it.
NOTE: The RS-232 & the LAN communication ports can not be used simultaneously.
PAGE 26