Analog Way Broad Scan HD - Manual (Page 6)

QUICK START GUIDE – BROAD SCAN (HD/SDI)
ANALOG WAY EDITION : 07/07
CONNECTIONS:
 Turn OFF all of your equipment before connecting.
 Connect the AC power supply cord to the BROAD SCAN and to an AC power outlet.
 Connect your computer sources to the COMPUTER INPUT (HD15) connector or the DVI-D INPUT connector.
 As required, connect a control monitor on the MONITOR OUT (HD15 or DVI-D) connector.
NOTE: The analog (RGB) MONITOR OUT is available only if the COMPUTER source is analog.
NOTE: The DVI-D MONITOR OUT is available only if the COMPUTER source is DVI-D.
 Connect your display device (TV monitor, VCR...) to the outputs (analog or SDI*).
 Turn ON the BROAD SCAN (rear panel switch). Then turn ON your input source and then your display devices.
* The SDI outputs are available on BHD930 & BSD830 models only.
• Example of connection (Model: BHD930-AG):
3
4 5
5 5
4
2
6
• RGB/COMPONENT output connection:
SETTINGS:
 We recommend resetting the BROAD SCAN to all of its default values, with the front panel display menu
(CONTROLdefault valueyes) before proceeding.
 Select the auto-setting menu with the front panel display menu (INPUTAuto setting) and activate this function with
ENTER. This function detects automatically the input type of the source connected to the input connectors (DVI &
RGB). Then the device performs an auto-centering function.
 Select the Input status menu (INPUTInput status) to verify the correct detection of the type and format of your input
source. If a wrong message is displayed, select manually the type of your input source (INPUTInput Type).
 Select the output format and rate (OUTPUTFormat).
 For SDTV output format (PAL, NTSC) select the type of the RGB/YCrCb output (OUTPUTType).
 Perform the needed image adjustments, available in the IMAGE menu.