Analog Way Broad Scan HD User Manual
Page 27
BROAD SCAN (HD/SDI)
Chapter 4 : FRONT PANEL DISPLAY MENU DESCRIPTION (continued)
4-5. FUNCTIONS DESCRIPTION (continued)
[LAN setup] + ENTER. (Available with the LAN option only)
Allows configuring the LAN communication port. Select the UDP or TCP protocol with + ENTER then
select items with + ENTER.
[device addr.]:
Every device connected to an IP network must have a unique IP address. This address is used
to reference the specific unit. IP addresses are specified as x.x.x.x where each x is a number
from 1 to 254. Assign the device to a unique IP address with + ENTER. (Default value:
192.168.0.2).
[remote addr.]: This is the destination IP address used with an outgoing connection. Select the destination IP
address with + ENTER. (Default value: 192.168.0.1).
[gateway addr.]: The gateway address, or router, allows communication to other LAN segments. The gateway
address should be the IP address of the router connected to the same LAN segment as the
unit. Select the gateway address with + ENTER. (Default value: 192.168.0.1).
[device port]:
Every TCP connection and every UDP datagram is defined by a destination IP address and a
port number. Select a local port number with + ENTER between 10000 and 10999.
(Default value: 10500).
[remote port]:
You must set the remote TCP port number for the unit to make outgoing connections. This
parameter defines the port number on the target host to which a connection is attempted.
Select a remote port number with + ENTER between 00000 and 655000. (Default
value: 10500).
[netmask]:
A netmask defines the number of bits taken from the IP address that are assigned for the host
section. The device prompts for the number of host bits to be entered, then calculates the
netmask, which displays in standard decimal-dot notation when the saved parameters are
displayed. Select the netmask with + ENTER. (Default value: 255.255.255.0).
[default setup]: Set all the LAN settings to the default value. Select [YES] and validate with ENTER.
MAC ADDRESS: The MAC address, also referred to hardware address, is a unique number assigned to each
device. The MAC address is available on the bottom device label.
[Key locking]
Select an item with and change the mode with ENTER.
[All]:
Locks/unlocks all the front panel switches.
[Menus]: Locks/unlocks the CONTROL switches.
NOTE: To unlock presses simultaneously on ENTER and EXIT.
[Stand-by]
[Auto After]: Select an item between:
[Sync loss]: The standby mode is automatically activate when the sync. of the selected input is not
anymore detected.
[Stand-by time]: The standby mode is activated after the duration of your choice.
[Sync loss + time]: The standby mode is activate when the sync. of the selected input is not anymore
detected and after the duration of your choice.
[Stand-by]: Manual activation of the Stand-by mode.
PAGE 27