Datamax-O'Neil DMXrfNetIII - Manual (Page 11)

P r i n t e r ’ s I n t e r n a l W e b P a g e s 9
WIRED ETHERNET CONFIGURATION Page
DHCP
ENABLED/DISABLED Controls IP Address discovery, where:
ENABLED: Broadcasts over the network to receive addresses from the responsible
server at startup. Manual modifications to IP Address, Subnet Mask, or Gateway are not
allowed; and, if no server is found, the specified static value will be used.
DISABLED: Uses the stored static IP, Subnet Mask, and / or Gateway Address.
STATIC IP ADDRESSES
PRINTER IP ADDRESS
PRINTER SUBNET MASK
PRINTER GATEWAY
These are the static address the printer will use when “DHCP” is set to disabled or a valid
IP could not be retrieved from a DHCP server.
ETHERNET PORT
CONNECTION SETTINGS
ETHERNET MODE Allows the User to specify the line duplex and speed of the wired Ethernet connection.
Auto-Negotiate (default) 10 BaseT Full Duplex
100 BaseT Full Duplex 10 BaseT Half Duplex
100 BaseT Half Duplex
ADVERTISE CAPABILITIES Selects the method in which the Duplex Capability setting is advertised, where:
Automatic (advertises the selected Duplex Capability setting)
All Capabilities (advertises all capabilities)
MINIMUM TRANSMISSION
UNIT (MTU)
Max Transmission Units Sets the Maximum Transmission Unit packet size, where:
Packet size, in bytes. (512-65515); Default is 1500
DMXrfNet3 Page
DHCP
ENABLED/DISABLED Controls IP Address discovery, where:
ENABLED: Broadcasts over the network to receive addresses from the responsible
server at startup. Manual modifications to IP Address, Subnet Mask, or Gateway are not
allowed; and, if no server is found, the specified static value will be used.
DISABLED: Uses the stored static IP, Subnet Mask, and / or Gateway Address.
STATIC IP ADDRESSES
PRINTER IP ADDRESS
PRINTER SUBNET MASK
PRINTER GATEWAY
These are the static address the printer will use when “DHCP” is set to disabled or a valid
IP could not be retrieved from a DHCP server.
WIRELESS TYPE
WIRELESS TYPE Specifies the type of network in which the Module will be used:
INFRASTRUCTURE = connects to WLAN using an AP.
ADHOC = used to connect two peer-to-peer devices.