Overview, Contents of the kit, Firmware update required – Datamax-O'Neil DMXrfNetIII User Manual
Page 3
O v e r v i e w
1
Overview
This document describes the installation and use of the DMXrfNetIII Card options for the H-Class and A-Class Mark II
printers. After verifying the contents of the kit and the tools needed, follow the steps below to install and begin using the
option. Keep this documentation for future reference.
CAUTION
For your safety and to avoid equipment damage, always turn ‘Off’ power and unplug the printer’s
power cord before beginning this installation.
Contents of the Kit
Note:
If your card is already installed proceed to “Card Setup and Operation”
This kit contains the following items:
Network Card Assembly
Rear Cover Plate
Screws
(Appearance may vary depending on card configuration.)
CAUTION
When handling the Network Card, observe proper electrostatic discharge precautions to prevent damage.
Firmware Update Required
If you are installing this card into an existing printer, you must upgrade the printers firmware to support this network card.
Updated firmware can be downloaded from the Datamax-O’Neil FTP site at ftp.datamax-oneil.com. Refer to the printers
operator’s manual for more information on updating the printers firmware. Be sure the firmware file that you download is:
All Models:
Version 14.033 or greater.
Before installing new firmware verify (via a Configuration Label) that the printer bootloader is version 14.033 or greater.