Datamax-O'Neil DMXrfNetIII - Manual (Page 12)

P r i n t e r ’ s I n t e r n a l W e b P a g e s 10
DMXrfNet3 Page (continued…)
ADHOC CHANNEL
ADHOC CHANNEL When Wireless Network Type is Ad Hoc, selects the channel used for communication. The
two peer-to-peer devices must use the same channel. Range is 1 to 14 channels. Default
channel is 1.
WIFI REGION CODE
WIFI REGION CODE Specifies the wireless channels allowed. The AP controls the channel used during
Infrastructure mode. Default is US.
SSID
SSID Service Set Identifier that identifies the Module to connect to an AP. To make this
connection, the Module and AP must have the same SSID. The SSID cannot contain
spaces. Default setting is the MAC address of the wireless module.
WIFI SECURITY
WIFI SECURITY Selects the WIFI SECURITY mode:
Disable WPA-PSK64
WEP64 WPA-PSK128
WEP128 WPA2-PSK
WPA-PSK TLS
WPA-LEAP PEAP
WPA-LEAP64 TTLS
WPA-LEAP128
WIFI AUTHENTICATION
WIFI AUTHENTICATION Selects the WIFI authentication method: (not available for all WIFI SECURITY modes)
AUTO = automatically detects the authentication. (default)
OPEN = communicates the key across the network.
SHARED KEY = allows communication only with devices with identical settings
WEP SETTINGS
WEP KEY USED Selects the default WEP Key from 1 – 4 if Shared Key or Both is selected for WEP
Authentication. Default is WEP Key 1.
WEP Key 1 through 4 Specify up to four WEP key values:
If WEP Encryption = 64, enter 10 hexadecimal digits for each key.
If WEP Encryption = 128, enter 26 hexadecimal digits for each key.
WPA SETTINGS
WPA Passphrase WPA-PSK 8 to 63 characters or 64 hex digits
LEAP SETTINGS
LEAP USER ID User ID for LEAP security mode; 1 to 32 characters
LEAP PASSWORD Password for LEAP security mode; 1 to 32 characters
EAP SETTINGS
EAP USER ID User ID for EAP security mode; maximum of 64 ASCII characters
EAP PASSWORD Password for EAP security mode; maximum of 64 ASCII characters
PEAP SETTINGS
OUTER AUTHENTICATION Selects PEAP v0 or PEAP v1
INNER AUTHENTICATION Selects MSCHAPv2, EAP MSCHAPv2, or EAP MD5