Datamax-O'Neil Workstation series Programmer’s Guide - Manual (Page 42)

1 | Programmer’s Guide
Thermal Printer Programmer’s Guide 36
KEYPROMPT Informs the user interface to
prompt the user for the next
label OFF, ON OFF
PAUSEMODE Same as KEYPROMPT OFF, ON OFF
CUTTER 7 When a cutter is installed, this
controls the cutting action for the
media OFF, ON, PERLABEL OFF
CUTBYCOUNT 10 The number of labels to print
before cutting 0-32767 1
REWINDER When the rewinder is installed,
this controls the operation and
direction of the powered internal
label rewinder OFF, CLOCKWISE,
COUNTERCLOCKWISE OFF
PRESENTSENSOR This controls the "on-demand"
dispensing of labels OFF, ON OFF
ERRORBUZZER Used to select the buzzer sound
for an error DISABLE, SOUND1,
SOUND2 DISABLE
WARNINGBUZZER Used to select the buzzer sound
for a warning DISABLE, SOUND1,
SOUND2 DISABLE
PRINTSPEED 6, 7, 9 Sets the print speed of the
printer 20 – 80 (1/10 IPS) 60
FEEDSPEED 9 Sets the feed speed of the
printer 0 – 120 (1/10 IPS) 0 (auto)
REVERSESPEED 9 Sets the speed at which the
label will be retracted into the
printer 0 – 50 (1/10 IPS) 0 (auto)
RETRACTTIMEOUT The length of time before the
presented label is retracted to
the next top of label 0 – 1000 (sec) 0
RETRACTDELAY The length of time before the
label is retracted at the next top
of label after the label has been
removed 10 – 1000 (ms) 70
LABELPRESENTDIST The distance, beyond the
bottom edge of the label, that
the label will be presented to the
user for removal. This is
measured in decipoints. 0 - 2880 (decipoints) 0 (auto)
PAPERLOWWARNING Show paper low warning OFF, ON OFF
PAPEROUTWARNING Show paper out warning OFF, ON ON
COVEROPENWARNING Show cover open warning OFF, ON ON
AUTOLOAD Sensors will trigger the
automatic load process when
paper is detected OFF, ON ON
AUTOOPTIONDETECT Controls the hardware
automatic detection OFF, ON ON
Variable Description Range Default