Datamax-O'Neil Workstation series Programmer’s Guide - Manual (Page 43)

Programmer’s Guide | 1
37 Thermal Printer Programmer’s Guide
AUTOCALIBRATE Automatically calibrates the
paper out sensors after loading
the paper OFF, ON ON
AUTOPRESENTDIST Enables the automatic setting of
the present distance OFF, ON ON
AUTOTENSION 6 Enables the automatic setting of
tension OFF, ON ON
AUTOPRESSURE 6 Enables the automatic setting of
pressure OFF, ON ON
AUTOMEDIAGLOBAL 6 Enables the automatic setting of
media parameters OFF, ON ON
AUTOSPEEDADJUST Enables the automatic speed
adjust OFF, ON ON
PAPERLENGTH
7 Sets the print length of the label
in decipoints (1/720th of an inch) 72 - 71280 (decipoints) 2880
PAPERWIDTH 7, 8, 11 Sets the print width of the label
in decipoints (1/720th of an inch) 72 - 3074 (decipoints) 2880
HORIZONTALOFFSET 7 Shifts the print area of the
logical page to the left or right on
the physical page in decipoints 0 - 2800 (decipoints) 0
VERTICALOFFSET 7 Shifts the print area of the
logical page up or down on the
physical page in decipoints 0 - 7200 (decipoints) 0
ORIENTATION 7 Controls the orientation of the
logical page on the physical
page PORTRAIT, LANDSCAPE,
RPORTRAIT,
RLANDSCAPE PORTRAIT
RASTERMODE 7 This controls how overlapping
images are placed on the paper TRANSPARENT,
OPAQUE TRANSPAREN
T
FONTNUMBER 1 This is the typeface number the
printer uses if none is specified
in the command stream 0 – 62 23
PITCH 1 This specifies the default
character pitch in characters per
inch. The default font must be a
fixed pitch font. 0.44 - 99.99 10.00
PTSIZE
1 This specifies the default point
size of the default font. The
default font must be scalable for
this to be effective. 4.00 - 999.75 12.00
SYMSET 1 This specifies the default
symbol set. The symbol set
must be resident in the printer. PJL sym set name3 PC8
PRINTTRUNCATION 7 This clips the print image at the
MARK or GAP. If the
PAPERTOFTYPE is "NONE"
then clip at PAPERLENGTH. OFF, ON ON
Variable Description Range Default