Datamax-O'Neil Workstation series Programmer’s Guide - Manual (Page 44)

1 | Programmer’s Guide
Thermal Printer Programmer’s Guide 38
PRINTONGAP Sets the printer to print on gap/
mark or not OFF, ON OFF
DARKNESS 7 This allows for the adjustment of
the darkness of the printed
image due to printhead thermal
variations. ± 20 0
SHARPNESS 4, 7 This allows for the adjustment of
the leading edge darkness of
the printed image due to
printhead thermal variations. ± 10 0
CONTRAST Same as SHARPNESS ± 10 0
VERTICALADJ
4 This allows for the vertical
adjustment of the start of image
relative to the horizontal leading
label edge due to mechanical
variations. ± 100 (dots) 0
HORIZONTALADJ 4 This allows for the horizontal
adjustment of the image relative
to the printhead center. ± 100 (dots) 0
PRESENTDISTANCEADJ 4 This allows for the adjustment of
the tear bar position due to
mechanical variations. ± 100 (dots) 0
CUTDISTANCEADJ 4 This allows for the adjustment of
the cut position due to
mechanical variations. ± 100 (dots) 0
HEADPRESSUREADJ 4 This allows for the adjustment
the pressure the printhead
exerts down on the media. ± 5 0
RIBBONTENSIONFADJ 4 This provides for the adjustment
of the front ribbon motor ± 10 0
RIBBONTENSIONRADJ 4 This provides for the adjustment
of the rear ribbon motor ± 10 0
REWINDTENSIONADJ 4 This provides for the adjustment
of the rewinder motor. ± 10 0
PAPERTRANSLEFT 4 Paper transmissive sensor
threshold for the inside sensor 0-255 128
PAPERTRANSRIGHT 4 Paper transmissive sensor
threshold for the outside sensor 0-255 128
PAPERREFLUPLEFT 4 Paper reflective sensor
threshold for the top inside
sensor 0-255 128
PAPERREFLUPRIGHT 4 Paper reflective sensor
threshold for the top outside
sensor 0-255 128
PAPERREFLDOWNLEFT 4 Paper reflective sensor
threshold for the bottom inside
sensor 0-255 128
Variable Description Range Default