Draw-Tite 41947 ULTRA FRAME RECEIVER - Manual

WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH.
INSTALLATION INSTRUCTIONS
Product No.
41947
SMALL PARTS
PACKAGE 41947F
IMPORTANT NOTES
USE ONLY MANUFACTURER’S SUPPLIED OR APPROVED
BOLTS, LOCKNUTS, AND WASHERS TO INSTALL THIS HITCH
CENTER SECTION ASSEMBLY
41947N 8-22-12 rev A PCN17317 © 2012 Cequent Performance Products Litho in USA
GENERAL INSTRUCTIONS:
1. Remove center section and side brackets from box. Refer to specific instructions for proper position of side
brackets.
2. Loosely install side brackets.
3. Install center section
4. Tighten center section fasteners , then frame attachment fasteners
FOR ALL INSTALLATIONS: UNLESS OTHER WISE NOTED
1. Torque all 9/16" grade 5 nuts & bolts to 120 lb.ft. (163 N*M) 2. Torque all 16mm CL10.9 hardware to 210 lb.ft. (285 N*M)
Note; Paint any bare metal to prevent rust.
TOOLS REQUIRED
13/16” , 7/8” SOCKET & WRENCH
21mm, 24mm SOCKET & WRENCH
11/16” DRILL BIT
TORQUE WRENCH
SAFETY GLASSES
MULTI-FIT
CENTER SECTION FASTENERS;
9/16”-18 x 1 3/4” HEX HEAD BOLT
9/16” HARDENED FLAT WASHER
9/16”-18 FLANGED LOCK NUT
CENTER SECTION
FASTENERS ARE TYPICAL
ON BOTH SIDES
3 HEIGHT LOCATIONS
FOR CENTER SECTION
(shown in location 3 – lowest)
Height from bottom of frame
to top of receiver tube
Location 1 = 6-5/8”
Location 2 = 8-1/4”
Location 3 = 10-1/4”
LOCATION 1
LOCATION 3
LOCATION 2
SIDE BRACKET
Do Not Exceed Lower of Towing Vehicle Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 16,000 (7264 kg) 1,600 (726 kg)
Weight Carrying
Ball Mount
15,000 (6810 kg) 1,600 (726 kg)