Draw-Tite 41947 ULTRA FRAME RECEIVER - Manual (Page 4)

FORD F-350, F-450, F-550
CAB AND CHASSIS ONLY
TOOLS REQUIRED
13/16”, 7/8” SOCKET
21mm, 24mm SOCKET
11/16” DRILL BIT
TORQUE WRENCH
SAFETY GLASSES
SIDE BRACKET
CENTER SECTION
TRUCK FRAME
RAIL
M16 X 2.0 CL10.9
LOCKNUT
M16 X 2.0 BOLT
M16 X 2.0 CL10.9
LOCKNUT
SEE FRONT PAGE FOR CENTER
SECTION FASTENERS
NOTE:
General assembly - loosely install side brackets on vehicle (this page); install center section assembly and
tighten all fasteners to proper specifications (page 1)
99-12 FORD F-350, F-450, F-550 CAB AND CHASSIS ONLY (34” FRAME)
1. Raise and clamp hitch side brackets into position, by centering on forward attachment hole between
suspension reinforcement and around frame rivets at rear crossmember.
2. Using the side bracket as a template, mark the frame at the center of each remaining attachment hole.
Warning; Do not drill into fuel or electrical lines, take appropriate precaution before step 3.
3. Remove the side bracket and drill 9/16” holes in frame. Hint; a small pilot hole is recommended.
4. Install side bracket loosely with the fasteners shown above.
5. Raise center section of hitch for vehicle requirements. Install center section with (8) 9/16” x 1-3/4” bolts,
washers, and flanged locknuts.
6. Tighten hitch side brackets to center section. Tighten hitch side brackets to truck frame.