Adder Technology X200 - Manual (Page 10)

wel
c
ome
c
ontent
s
inst
all
ation
&
op
era
tion
sp
ecial
c
onfigura
tion
fur
t

er
informa
tion
9
Special configuration
Configuration
You can alter the way that the X200 module operates to suit your requirements.
This is done using the Configuration mode and you can affect the following
settings:
• Password.setting – allows you to lock the remote module to prevent
unauthorised system access.
• Mouse.switching.control - determines whether channels may be selected
using a three button mouse.
• Video.compensation - sharpness & brightness – allows you to manually
adjust the video image to ensure that it is crisp and bright.
• Video.skew.adjustment - X200AS models only - allows you to compensate
for the effects of long cable runs on colour reproduction.
• Miscellaneous.settings – report firmware version and restore settings.
What are hotkeys?
Hotkeys are two normal keyboard keys that, when pressed simultaneously with a
third key, signal to the X200 module that you are sending a message specifically
to it and not to the connected computer. The hotkeys are ordinarily
and ,
while a third keypress determines what you want the module to do.
If the standard
and hotkeys are also needed for computer tasks, you
can change them for another combination using switches 2 and 3 on the X200
remote module:
2 OFF
3 OFF
Hotkeys = and (default setting)
2 OFF
3 ON
Hotkeys = and
2 ON
3 OFF
Hotkeys = and
2 ON
3 ON
Hotkeys disabled
Entering, using and exiting configuration mode
To enter and use configuration mode:
1 Simultaneously press the currently configured
hotkeys (by default, and ) along with .
The three keyboard indicators (‘Num Lock’, ‘Caps
Lock’ and ‘Scroll Lock’) will now begin to flash in
sequence to show that you are in configuration
mode.
2 Press the first letter of the required configuration
option, for instance .
All three keyboard indicators will illuminate
continuously.
3 Press the number of the required configuration
option, for instance .
The ‘Scroll Lock’ indicator will extinguish, leaving
the ‘Num Lock’ and ‘Caps Lock’ indicators lit.
4 Press to confirm your option.
The three keyboard indicators (‘Num Lock’, ‘Caps
Lock’ and ‘Scroll Lock’) will now begin to flash in
sequence again.
To exit from configuration mode:
1 Within configuration mode, the three keyboard indicators should be flashing
in sequence to show that the module is ready to receive a new command.
2 Press .
The three indicators will return to their normal states.
Num Loc
k
Caps Loc
k
Scroll Loc
k
Num Loc
k
Caps Loc
k
Scroll Loc
k
HT