Adder Technology X200 - Manual (Page 7)

wel
c
ome
c
ontent
s
inst
all
ation
&
op
era
tion
sp
ecial
c
onfigura
tion
fur
t

er
informa
tion
6
PW
R
TO LO CA
L1
TO
LO CA L2
Connections at the X200 (remote) module
1 Place the X200 module adjacent to the remote user location.
2 Attach the video monitor, USB keyboard, USB mouse and speaker
connectors to the sockets of the Adder X200 module.
3 Attach the connector of each cable run leading from the CAMs (and/or
AdderView CATx switch) to the TO LOCAL  and TO LOCAL  sockets of the
X200.
REMO
TE
ADD
From USB
mouse and
keyboard
From
speakers
From
video
monitor
Adder X00
module
4 Insert the output connector of the power supply into the socket at the front
edge of the X200 module labelled POWER .
5 Insert the IEC connector of the supplied power lead into the corresponding
socket of the power supply. Connect the other end of the power lead to a
nearby mains socket.
6 Where necessary, use the in-built video compensation feature to eliminate
any effects caused by the cable run. See Video.compensation for details.
From
power
adapter
Category , e or 6
cables leading to the
CAM modules or CATx
switch (which are
attached to the host
computers)
Adder X00
module
PW
R
TO
LO
CA
L1
TO
LO
CA
L2
Green indicators - On when the corresponding channel is selected
Yellow indicators - On when link to CAM or CATx switch is made
Flashing to show signal activity
Both green indicators off - X00 module is password locked
Green indicator for channel  flashing - X00 is in flash upgrade mode (SW ON)
Red indicator - power present
X00 indicators