Draw-Tite 9480 HIDE-A-GOOSE FIFTH WHEEL ADAPTER - Manual (Page 11)

11. Place the skid plate assembly onto the center section assembly. Keep hands clear of pinch points while placing/removing
head onto/off hitch base as noted on head labels. Head will tilt rearward.
12. Insert the pull pins and retaining clips shown below. Note that the pull pins used with the Hi-Rise hitch are 90 degree bent
pins and if replacements are needed, please contact the factory.
13. Lube jaw and skid plate(If no lube plate is being used) with automotive type chassis grease. The jaw pin comes greased
from the factory. To insure smooth jaw operation, grease should be added every 6 months to grease fitting on top of head.
WARNING:
Tilting 5 th Wheel head can
crush and cut. Keep hands and
fingers clear from this area at
all
times (including
placement/removal of head).
Grease Fitting
Sight Hole
S
WARNING:
To prevent tilting head
detachment and or
Retaining Clip
Both Sides
Both Sides
Lube Skid Plate
(if not using a lube
plate)
Lube Jaw
detachment and or
separation of hitch you must
make sure that the anchor
assemblies
are properly
installed and pinned, and
the spring retaining clip is
properly installed onto the
½” pull pin before towing.
The retaining clip can easily
Pull Pin The retaining clip can easily
be seen through the sight
holes in the top of the head.
Figure 16
Pull Pin
Both Sides
14. Attach the handle assembly to the skid plate assembly using the 3/8 carriage bolts, lock washer and hex nuts.
15 Slide the handle grip over the handle tube 15. Slide the handle grip over the handle tube.
z 2010, 2011 Cequent Performance Products Sheet 11 of 12 9480N 6-22-11 Rev. C
Figure 17