Draw-Tite 9480 HIDE-A-GOOSE FIFTH WHEEL ADAPTER - Manual (Page 6)

Hi-Rise FIFTH WHEEL ASSEMBLY
ASSEMBLY AND ADJUSTMENT
IS REQUIRED BEFORE INITIAL USE.
SOME USERS MAY REQUIRE MORE EXTENSIVE ADJUSTMENTS. THE TOOLS NEEDED FOR THESE
ADJUSTMENTS ARE LISTED BELOW.
POSSIBLE TOOLS NEEDED IF FURTHER ADJUSTMENT ARE REQUIRED
7/16”, 9/16” and 15/16" Socket, Open End Wrenches, Phillips Screw Driver,
200 lb-ft Torque Wrench
1. Check the box for all components listed in Figure 1 and become familiar with component terminology.
2. Determine from the Guide Lines portion of this instruction sheet (Pages 2 – 4 ) the height of the hitch that is required and
position at the correct setting. See Chart 1 on page 7 as a guide to determine which direction to attach the center section
to the base assembly. Attach the center section to the base assembly using the 5/8” Bolts and Lock washers (see Figure
9). Torque the 5/8 fasteners to 170 ft-lb. (230 N*M).
5/8” BOLT
5/8” LOCK WASHER
14-1/4” 14 1/4
15-1/2”
16-3/4”
18”
CENTER SECTION
FIGURE 9
z 2010, 2011 Cequent Performance Products Sheet 6 of 12 9480N 6-22-11 Rev. C