Avocent CCM1640 - Manual (Page 44)

38 CCM840/1640 Installer/User Guide
To add or delete SNMP management entity addresses:
1. To add an SNMP management entity address, issue a Server SNMP
Manager command with the Add parameter and the management
entity’s IP address. You may defi ne up to four SNMP management entity
addresses, using separate commands.
SERVER SNMP MANAGER ADD <ip_address>
When you defi ne at least one SNMP manager, SNMP requests are processed
if they are from one of the defi ned SNMP managers. If a request is not from
one of the defi ned SNMP managers, the SNMP request is discarded.
2. To delete an SNMP management entity address, issue a Server SNMP
Manager command with the Delete parameter and the management
entity’s IP address.
SERVER SNMP MANAGER DELETE <ip_address>
If no management entities are defined, any SNMP manager may access the
MIB. For more information, see Server SNMP Manager command in Chapter 5.
To enable or disable SNMP traps:
1. To enable SNMP traps, issue a Server SNMP Trap command with the
Enable parameter.
SERVER SNMP TRAP ENABLE
The CCM will display a numbered list of traps that are currently disabled
with a prompt requesting you to select trap(s) to enable. Indicate the traps
to be enabled by entering a trap’s list number, several numbers separated
by commas, a range of numbers separated by a dash or a combination
of numbers with commas and dashes. To enable all traps, type ALL. To
cancel the command, press Enter.
- or -
To enable all SNMP traps, issue a Server SNMP Trap command with the
Enable and All parameters. In this case, the numbered list is not displayed.
SERVER SNMP TRAP ENABLE ALL
2. To disable SNMP traps, issue a Server SNMP Trap command with the
Disable parameter.
SERVER SNMP TRAP DISABLE
The CCM will display a numbered list of traps that are currently enabled
with a prompt requesting you to select trap(s) to disable. Indicate the traps
to be disabled by entering a trap’s list number, several numbers separated
by commas, a range of numbers separated by a dash or a combination
of numbers with commas and dashes. To disable all traps, type ALL. To
cancel the command, press Enter.