Burkert Type 8619 - Manual (Page 6)

4
Intendeduse
2. inTenDeD use
use of this device that does not comply with the instructions could present risks to people, nearby
installations and the environment.
• The device is intended, depending on the modules fitted and the measurement sensors connected, for the
acquisition, processing, transmission and regulation of physical parameters such as pH, conductivity, tem-
perature or flow rate... .
• This device must be protected against electromagnetic interference, ultraviolet rays and, when installed out-
doors, the effects of climatic conditions.
• This device must be used in compliance with the characteristics and commissioning and use conditions
specified in the contractual documents and in the user manual.
• Requirements for the safe and proper operation of the device are proper transport, storage and installation, as
well as careful operation and maintenance.
• Only use the device as intended.
→
Observe any existing restraints when the device is exported.
3. bAsic sAfeTy informATion
This safety information does not take into account:
• any contingencies or occurrences that may arise during assembly, use and maintenance of the device.
• the local safety regulations that the operator must ensure the staff in charge of installation and maintenance
observe.
Danger due to electrical voltage.
• Shut down and isolate the electrical power source before carrying out work on the system.
• Observe all applicable accident protection and safety regulations for electrical equipment.
various dangerous situations.
To avoid injury take care:
• to prevent any unintentional power supply switch-on.
• to carry out the installation and maintenance work by qualified and skilled staff with the appropriate tools.
• to guarantee a set or controlled restarting of the process after a power supply interruption.
• to use the device only if in perfect working order and in compliance with the instructions provided in the user
manual.
• to observe the general technical rules during the planning and use of the device.
• not to use this device in explosive atmospheres.
• not to use this device in an environment incompatible with the materials from which it is made.
• not to make any external modifications to the device such as for instance painting or varnishing any part of the
device.
• not to power the device with an AC voltage or a DC voltage higher than 36V DC.
Type 8619
english