Burkert Type 8056 - Manual (Page 14)

SE56
14
INPUT OPERATION STAGE (GENERIC FUNCTIONS)
Auto-calibration
Reset totalizers
Block totalizers
Block totalizers
Totalizers active
Necessary conditions for enable the function
Necessary conditions for enable the function
Necessary conditions for enable the function
Tmin<T<1sec. = autocalibration
T > 1 sec. = Autozero
x
POS. 5.6 ENABLED
x
POS. 5.8-9-10 batch functions assign to input 1-2-3
(optional) DISABLED
x
POS. 6.1-2-3-4 batch functions assign to output 1-2-
3-4 DISABLED
x
POS. 5.1-2 ENABLED at least one
x
POS. 5.4 ENABLED
x
POS. 9.5 (auto-batch) DISABLED
x
POS. 9.7 (cons. mode) DISABLED
x
POS. 5.7 ENABLE
x
POS. 5.8 (batch on input 1) DISABLED
x
POS. 5.9-10 batch functions assign to input 2-3
(optional) DISABLED
Necessary conditions for enable the function
Range change
THE FUNCTIONS POINT OUT ABOVE ARE ENABLED ONLY ON INPUT 1
Scale 2
Scale 1
Measure blocked
Measure
Measure lock
Necessary condition for enabling the function
POS. 5.5 ENABLED (measure lock)
0-1.5 V
3-40 V
AUTOCALIB. OFF
T
RESET
0-1.5 V
3-40 V
Tmin = 100ms
BLOCK
0-1.5 V
3-40 V
T
0-1.5 V
3-40 V
18-30V
<18V