Burkert Type 8070 - Manual (Page 20)

18
SettingandFunctions
Setting in the parameter:
This function is not available on a “Version 1” device. Refer to the nameplate
Status display
changes to „active“
Enter K factor *
* K factor, see operating instructions of the fitting used
selection of paddle-
wheel sensor
selection of paddle-
wheel sensor
selection of
oval wheel sensor
Select fitting
Select material
Select fitting diameter **
T-fitting
Metal (stainless steel or brass)
DN06
** The display depends on the selected
sensor:
Sensor 8020: DN15 ... DN400
Sensor 8030: DN06 ... DN50
Sensor 8070: DN15 ... DN100
Saddle
PVC
Welding tab or fusion spigot
PP
Screw-on
PVDF
DN400
K factor is shown
KF
Order of value input:
1. Select the decimal point place (each time
the key is pressed: one position to the left)
2. Set numerical values
Fig. 12: Input – Setting the K factor
English
Type 8022