Burkert Type S039 - Manual (Page 22)

ENGLISH ENGLISH
flow rate controller 8039
** To use the «Teach-In» feature, connect the 8039 controller to a valve which makes it possible to fill a tank with a capacity of
x litres (200 litres for instance).
When the display shows «YES TEAC», press the «ENTER» key and open the valve: The «TEAC» message flashes.
When the tank is full (200 litres), press «ENTER» again. By means of keys 0......9 and
ENTER
enter the volume of fluid which
circulated through the circuit (200 litres): the controller calculates the K factor and displays it.
OHI>
OLO
0......9
ENTER
1
ENTER
0......9
ENTER
0......9
2
ENTER
ENTER
ENTER
ENTER
ENTER
0......9
0......9
ENTER
ENTER 0......9 0......9
0......9
ENTER ENTER ENTER
0......9
ENTER
ENTER ENTER
ENTER
ENTER ENTER
0......9
...
ENTER
0......9
ENTER ENTER
ENTER
ENTER
ENTER ENTER
0......9
0......9
*
*
* *
* *
to enter the K-factor (refer
to the fitting manual) or have
it calculated through the
Teach-in feature.
K is the multiplication coeffi-
cient between the rotational
frequency of the S039 pad-
dle-wheel and the flow rate to
be measured.
 proGramminG
. calibration mode
to choose the flow rate unit
(l/s, l/min, l/h, m 3 /min, m 3 /h,
Ga/s, Ga/min, Ga/h).
to go back to the previous
function.
to go to
the next function.
if you change the flow rate unit,
change the switching threshold
values, too.
UNIT
L/S
GA/H
KFAC
NO
TEAC
YES
TEAC TEAC
0.534
KFAC
200.0
L/S
0.534
KFAC
**
* To move the decimal point, press simultaneously keys
0......9
and