3 operation, 4 storage and transport – Burkert Type 8112 User Manual
Page 9
3
.3 Operation
The switching condition of LEVEL SWITCH 8112 can be checked
when the housing is closed (signal lamp). With the basic setting,
products with a density > 0.7 g/cm³ (0.025 lbs/in³) can be detected.
The instrument can be adapted if products with lower density should
be measured.
On the electronics module you will find the following indicating and
adjustment elements:
l
Signal lamp for indication of the switching condition (green/red)
l
DIL switch for sensitivity adjustment
l
Mode adjustment for selection of the switching condition (A/B)
3
.4 Storage and transport
Your instrument was protected by packaging during transport. Its
capacity to handle normal loads during transport is assured by a test
according to DIN EN 24180.
The packaging of standard instruments consists of environment-
friendly, recyclable cardboard. The sensor is also equipped with a
protective cap of ABS. For special versions, PE foam or PE foil is also
used. Dispose of the packaging material via specialised recycling
companies.
Transport must be carried out under consideration of the notes on the
transport packaging. Nonobservance of these instructions can cause
damage to the device.
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or
concealed defects must be appropriately dealt with.
Up to the time of installation, the packages must be left closed and
stored according to the orientation and storage markings on the
outside.
Unless otherwise indicated, the packages must be stored only under
the following conditions:
l
Not in the open
l
Dry and dust free
l
Not exposed to corrosive media
l
Protected against solar radiation
l
Avoiding mechanical shock and vibration
l
Storage and transport temperature see chapter "Supplement -
Technical data - Ambient conditions"
l
Relative humidity 20 … 85 %
Packaging
Transport
Transport inspection
Storage
Storage and transport
temperature
LEVEL SWITCH
8112 • with NAMUR output
9
3 Product description
32052
-
EN
-
120418