ELRO CR1 WLAN Repeater USERS MANUAL - Manual (Page 33)

802.11n WiFi Repeater User’s Manual
33
14. Now you could see the APs that scanned by the WiFi
Repeater were listed below.
15. Click on the ratio of AP’s SSID under the item Select that
you want the WiFi Repeater to connect to.
16. Enter the related parameters.
17. Click Connect button.
18. Please wait...
19. Connect successfully! Please wait 2 minutes while booting.
20. If the WPS LED is on, the 802.11n WiFi Repeater has been
configured completely, and suitable for Wireless and
Internet Connections.
21. If the WPS LED isn’t on, reset the device to factory by
pressing reset button for 6 full seconds and configure again.