ELRO CR1 WLAN Repeater USERS MANUAL - Manual (Page 37)

802.11n WiFi Repeater User’s Manual
37
network. The device is preconfigured with default settings for
use with a typical home or small office network.
The table below lists some of the most important default
settings; these and other features are described fully in the
subsequent chapters. If you are familiar with network
configuration, review these settings to verify that they meet the
needs of your network. Follow the instructions to change them if
necessary. If you are unfamiliar with these settings, try using the
device without modification, or contact your ISP for assistance.
WARNING
We strongly recommend that you contact your ISP prior to
changing the default configuration.
Option Default Setting Explanation/Instructions
WAN Port IP
Address DHCP Client This is the temporary public IP address of the WAN
port on the device. It is an unnumbered interface that
is replaced as soon as your ISP assigns a ‘real’ IP
address. See Network Settings -> WAN Interface.
LAN Port
IP Address Assigned static IP address:
192.168.0.1
Subnet mask:
255.255.255.0 This is the IP address of the LAN port on the device.
The LAN port connects the device to your Ethernet
network. Typically, you will not need to change this
address. See Network Settings -> LAN Interface.
DHCP (Dynamic
Host Configuration
Protocol) DHCP server enabled with the
following pool of addresses:
192.168.0.100
through
192.168.0.200 The device maintains a pool of private IP addresses
for dynamic assignment to your LAN computers. To
use this service, you must have set up your
computers to accept IP information dynamically, as
described in Configuring Ethernet PCs.